Pumps

Hydraulic Pumps are air driven. For most systems shop air is regulated down to 71 psi to achieve a 5000 psi hydraulic pressure output.

Hydraulic valves are manually controlled or electrically opened and closed based on signals from a programmable logic controller (PLC).

Hydraulic pumps include pressure gauges and also pressure sensors if connections are to be made to press controls.

Model 108 - Single Zone

Shop air driven.

Pressure regulator controls hydraulic pressure from 1000 to 5000 psi.

May be press mounted vertically or horizontally or used as a portable unit.

Compact, lightweight (20 lbs.).

Model 125 - Two Zone 'Carriable'

Compact, air driven, portable, high capacity hydraulic power source for hydraulic clamps and other applications.

Pressure regulator controls hydraulic pressure from 1000 to 5000 psi.

Two individually controlled hydraulic circuits with pressure gauge for each circuit.

Convenient carrying handle and rubber feet.

Weighs approximately 30 lbs.

 Model 130           Model 140                                               

The Model-130 has three independent hydraulic circuits, the Model 140 four. Pressure gauges show the hydraulic pressure in each circuit.

Hydraulic pressure may be adjusted from 1000 psi to 5000 psi. Both models are shop air driven.

Each hydraulic circuit is controlled by a manually turned valve. Each valve contains a check valve.

A pressure sensor is included when applications requires communication of low pressure to press controls.

The units may be shelf mounted or placed on a pedestal. Wheels are placed on the pedestal if the unit is used in various locations.

Model 113

Stationary, three PLC controlled electrically actuated valves. These pumps are used as described above. Two, three and four circuit pumps are available.